Image 8 Manuel d'utilisateur télécharger pdf (Page 20)

Before using the weight system, pull each cable a few times to be sure that the cables move smoothly over

the pulleys. If one of the cables does not move smoothly, find and correct the problem. IMPORTANT: If the

cables are not properly installed, they may be damaged when heavy weight is used. See the CABLE

DIAGRAMS on page 25 and 26 of this manual for proper cable routing. If there is any slack in the

cables, you will need to remove the slack by tightening the cables. See TROUBLE-SHOOTING AND

MAINTENANCE on page 24.

54. Lubricate a 1/2” x 4” Bolt (68). Attach the Foot

Press Plate (29) to the Press Leg Lever (90) with

the Bolt and a 1/2” Nylon Jamnut (36).

55. Press two 3/4” Round Inner Caps (43) into each of

the two Pad Tubes (42).

Slide a Foam Pad (30) onto one side of a Pad Tube

(42). Slide the Pad Tube through the hole in the

Leg Lever (41). Slide another Foam Pad onto the

other side of the Pad Tube.

Slide a Foam Pad (30) onto one side of the other

Pad Tube (42). Insert the Pad Tube through the

welded tube on the Butterfly Front Leg (3). Slide

another Foam Pad onto the other side of the Pad

Tube.

56. Attach the Curl Pad (91) to the Preacher Post (39)

with four 1/4” x 3/4” Bolts (49).

Slide the Preacher Post (39) into the Butterfly Front

Leg (3) and secure it by inserting the Large

Adjustment Knob (46) and turning it clockwise until

tight.

57. Make sure that all parts have been properly tightened. The use of the remaining parts will be explained in

ADJUSTMENTS, beginning on page 21 of this manual.

Welded

Tube

Lubricate

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 31 32

Pas de commentaire

Image 8 Manuel d'utilisateur Page 20