Image 8 Manuel d'utilisateur télécharger pdf (Page 10)

14. Insert a 2” Square Inner Cap (28) into the end of a

Butterfly Arm (10).

Attach a Butterfly Handle (53) to the Butterfly Arm

(10) with two 3/8” x 1” Bolts (84) and two 3/8” Flat

Washers (48).

Repeat this step with the other Butterfly Arm (10).

15. Lubricate a 3/8” x 3 1/4” Bolt (62). Attach the left

Butterfly Arm (10) to the Left Pivot Arm (71) with

the Bolt and a 3/8” Nylon Locknut (50).

Repeat this step with the right Butterfly Arm (not

shown) and the Right Pivot Arm (85).

17. Insert a 2” Square Inner Cap (28) into the top of a

Press Arm (77). Press two 1” Round Inner Caps

(86) into the outside ends of the handles.

Attach the Press Arm (77) to the Press Frame (8)

with two 5/16” x 2 3/4” Bolts (96) and two 5/16”

Nylon Locknuts (64).

Repeat this step with the other Press Arm (77).

Lubricate

Handles

16. Lubricate a 1/2” x 4” Bolt (68). Attach the Press

Frame (8) to the Press Base (6) with the Bolt and a

1/2” Nylon Jamnut (36). Note: Be sure the Press

Frame is oriented with the indicated hole closer

to the Press Upright (2). Do not over tighten the

1/2” Nylon Jamnut; the Press Frame must be

able to pivot easily.

Lubricate

Hole

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Pas de commentaire

Image 8 Manuel d'utilisateur Page 10