Image 8 Manuel d'utilisateur télécharger pdf (Page 11)

20.

Locate and open the parts bags labeled “CABLE

ASSEMBLY” and “PULLEYS.”

Secure a 3/8” x 2 1/4” Bolt (79) to the Right Pivot

Arm (85) with a 3/8” Nylon Jamnut (63).

Locate the Butterfly Cable (73), which is the

shorter cable of the two that have loops on both

ends. Attach the Butterfly Cable to the 3/8” x 2 1/4”

Bolt (79) with a 3/8” Nylon Jamnut (63). Note: Do

not fully tighten the Nylon Jamnut; the Butterfly

Cable must be able to pivot easily.

18. Attach a Bumper (40) to the Press Front Leg (20)

with a 1” Tap Screw (80).

Press a 2” x 3” Inner Cap (78) into the top of the

Press Leg Lever (90).

Lubricate a 1/2” x 4” Bolt (68). Attach the Press Leg

Lever (90) to the Press Base (6) with the Bolt and a

1/2” Nylon Jamnut (36). Note: Do not over tighten

the Nylon Jamnut; the Press Leg Lever must be

able to pivot easily.

19. Insert two 2” Square Inner Caps (28) into the Leg

Lever (41).

Attach a Bumper (40) to the Butterfly Front Leg (3)

with a 1” Tap Screw (80).

Lubricate a 3/8” x 3” Bolt (88). Attach the Leg Lever

(41) to the Butterfly Front Leg (3) with the Bolt and

a 3/8” Nylon Jamnut (63). Note: Do not over tight-

en the Nylon Jamnut; the Leg Lever must pivot

easily.

21. Wrap the Butterfly Cable (73) over a “V”-Pulley

(27). Attach the Pulley and a Large Cable Trap (32)

to the bracket on the Butterfly Upright (1) with a

3/8” x 2 1/2” Bolt (87) and a 3/8” Nylon Locknut (50).

CABLE ASSEMBLY

Lubricate

IMPORTANT: While assembling the cables, do

not overtighten the bolts and nuts attaching

the pulleys. The pulleys must be able to turn

freely. Refer to the Cable ID Chart on page 26

for help identifying the cables.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Pas de commentaire

Image 8 Manuel d'utilisateur Page 11