Image 8 Manuel d'utilisateur télécharger pdf (Page 12)

22. Remove the preassembled 3/8” x 2” Bolts (54) from

one set of Adjustable Pulley Plates (23).

Wrap the Butterfly Cable (73) around a 3 1/2”

Pulley (24). Attach the Pulley and a Cable Trap (25)

between the top holes of the Adjustable Pulley

Plates (23) with a 3/8” x 2” Bolt (54) and a 3/8”

Nylon Locknut (50). Be sure that the Cable Trap

is turned to hold the Cable in place.

23. Wrap the Butterfly Cable (73) around a “V”-Pulley

(27). Attach the Pulley and a Large Cable Trap (32)

to the bracket on the Butterfly Upright (1) with a

3/8” x 2 1/2” Bolt (87) and a 3/8” Nylon Locknut

(50). Be sure that the Cable Trap is turned to

hold the Cable in place.

24. Secure a 3/8” x 2 1/4” Bolt (79) to the Left Pivot

Arm (71) with a 3/8” Nylon Jamnut (63).

Attach the Butterfly Cable (73) to the 3/8” x 2 1/4”

Bolt (79) with a 3/8” Nylon Jamnut (63). Note: Do

not fully tighten the Nylon Jamnut; the Butterfly

Cable must be able to pivot easily.

25. Locate the Ab Cable (47). Insert the Ab Cable up

through the Press Top Frame (9) and wrap it

around a 3 1/2” Pulley (24). Attach a 3/8” Flat

Washer (48) and a 5/8” x 3/4” Bushing (66) to a

3/8” x 3 1/4” Bolt (62). Slide the Bolt through the

Press Top Frame and the Pulley. Secure another

5/8” x 3/4” Bushing and 3/8” Flat Washer to the Bolt

with a 3/8” Nylon Locknut (50).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Image 8 Manuel d'utilisateur Page 12