Image 8 Manuel d'utilisateur télécharger pdf (Page 9)

11. Secure the Press Top Frame (9) to the Butterfly Top

Frame (33) with two 3/8” x 3 1/4” Bolts (62), two

3/8” Flat Washers (48), and two 3/8” Nylon

Locknuts (50). Do not tighten the Nylon Locknuts

yet.

12. Secure the Weight Guides (15) to the Press Top

Frame (9) with two 3/8” x 1 3/4” Bolts (57) and two

3/8” Nylon Locknuts (50).

Tighten the Nylon Locknuts used in steps 2–12.

Lubricate

Axle

13. Locate and open the parts bag labeled “ARM

ASSEMBLY.”

Press a 1 1/2” Square Inner Cap (35) into the back

of the Right Pivot Arm (85). Lubricate the axles on

the Butterfly Top Frame (33). Secure the Right Pivot

Arm to the right axle with two Retainer Rings (31)

and a 1” Round Outer Cap (38). Do not confuse

the Right Pivot Arm with the Left Pivot Arm (not

shown).

Note: Be sure the Retainer Rings (31) and 1”

Round Outer Cap (38) are oriented as shown in

the inset drawing. The Retainer Rings may

break if disassembled.

Repeat this step with the Left Pivot Arm (not shown)

and left axle.

ARM ASSEMBLY

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Pas de commentaire

Image 8 Manuel d'utilisateur Page 9